T-Probe-25ft-1 - Temperature Sensor with 25 foot cable

This 25 foot temperature sensoring cable is compatible with all LINK and LINKHub interfaces. While the RJ45 connector comes standard should a different connection be needed, simply remove the RJ45 and replace with the appropriate connection (or hard wire the T-Probe into the bus). There is no specification on length but it will deteremine the 1-Wire bus criteria; power, weight, RFI, etc. 

The lower third of the sensing unit is enclosed by our low pressure molding machine. The molding material used is from Macromelt. Click here for detailed specifications. The product type used in iButtonLink products is OM633. The insulation on the cable is PVC. The temperature range of PVC is +60 degrees C (+140 F); high temp cable is available. Contact factory.
NOTE: The full temperature range of the sensor (-55C to +125C) is supported by the molding media.

Temperature response and settling times are shown in Appendix 1 of the T-Sense Manual, along with full spec sheet on the DS18B20. 

All 3 leads of the DS18B20 are brought straight through to the RJ45 connector, giving the user full access to the DS18B20. Pin assignments follow our standard, looking into the female end of the RJ45 connector (the male end will have pin 1 on the right side when looking into the end):

 
Pin 1 = +5 volt return (unused)
Pin 2 = +5 volts (Vdd) Orange wire
Pin 3 = Aux return (unused)
Pin 4 = 1-Wire® data Blue wire
Pin 5 = 1-Wire® return Blue and White wire
Pin 6 = Aux (unused)
Pin 7 = +12 volts (unused)
Pin 8 = +12 volts return (unused) 

DO NOT plug the T-probe directly into a LinkTH or Link45 master. Use a LinkUSB master instead, if a direct connection is desired. 

Custom cable lengths are available. Minimum quantity order of 25; contact factory for price and delivery.

*This product is compatible with and used in AEM systems.